USB Graphics Tablet PDF User’s Guide

Installing the Battery into the Pen
Unscrew the end cap of the pen. Slide off the pen clip and cover. Insert the battery (1.5 volt, size AAAA) with the minus (-) side of the battery facing toward the pen tip. Replace the pen cover and clip. Screw the end cap.

Note!
If you place this pen in a container where the pen rests on the tip, the pen remains active and battery life is shortened. We recommend you to place the pen horizontally on the table. For 5″x3.75″ tablet, you also can place the pen in the tablet’s pen holder case. Installing the Tablet for Windows

Before you install the tablet for your Windows, you must remove any tablet driver if you have installed any tablet driver in your Windows.
1. Turn on your computer and start Windows.
2. Plug the USB connector of the tablet into an USB port. The LED on the tablet will light. If the LED does not light, this USB port may not be
available.
3. Insert the tablet CD into your CD-ROM drive. The setup menu of the tablet should automatically display. If the setup menu does not display,
double-click the Setup icon on the tablet CD. Click Install USB Tablet Driver.
4. For Windows 2000, click Finish. Click Yes and then click OK. For Windows XP, click Finish. Click Continue Anyway and then click OK.
5. When finished, the tablet is a Windows system pointing device for all Windows applications. Use the pen tip to quickly click anywhere to turn
on the pen. Now you can use the pen on the tablet to move the screen cursor.

The pen operates on one battery. If the pen tip clicking or pressing has not occurred for about three minutes, the pen automatically turns off to save the life of battery and then you can not use the pen to move the screen cursor. (The LED on the tablet shows red when the pen turns off and is within the reading range of the tablet.) To turn on the pen, use the pen tip to quickly click anywhere. Then you can use the pen again to move the screen cursor. (The LED on the tablet shows green when the pen turns on and is within the reading range of the tablet.) Whether the pen turns on or off, the LED shows red when the pen is out of the reading range of the tablet.

Customizing the Pen and Tablet in Windows
In Windows, open the Tablet icon from the Control Panel window. The Tablet dialog box appears. In this dialog box, you can change the following
settings for the way you like to work. Button Functions To change the button functions of the pen, click the Buttons tab. From the list boxes of the Button Label and Action, you can redefine the button functions such as Left-Click, Left Double-Click, Right-Click, Middle-Click, Copy, Paste, and so on.

Tip Feel
You can adjust the tip feel you prefer when clicking or drawing. To adjust the amount of pressure needed to click with the pen tip or to draw
non pressure-sensitive lines, click the Tip Feel tab and then drag the Click Pressure slider toward Soft or Hard. Other Settings — Please refer to the User’s Manual in the tablet CD.

Installing the Tablet for Mac
1. Turn on your computer.
2. Plug the USB connector of the tablet into an USB port. The LED on the tablet will light. If the LED does not light, this USB port may not be
available.

Note!
Before you install the tablet driver, you can use the pen on the tablet to move the screen cursor but the functions of the pen are not yet available.

Download USB Graphics Tablet PDF User’s Guide


January 17, 2010 | Posted in Electronic Manual, Notebook Manual

Related Info:

Comments

Leave a Reply