Toshiba Satellite T200 – T410 Battery Pack PDF User Manual
Step 1: Read the user manual carefully to make sure the proper operation with the battery pack.
Step 2: Refer to the guidance of your notebook computer or check the label on notebook computer to confirm the brand and model. Take IBM T40 as an example.
Step 4: Set the battery pack’s output voltage at proper level by pushing the voltage switch.
Step 5: Press the switch (in the middle) on battery pack, check LED indicator. If only one or no indicator lights, it means the power is not enough, you have to charge the battery pack fully firstly (refer to how to charge).
Step6: Make sure the battery pack is fully charged, connect the selected output tip and output cable together, then insert one terminal of output cable into DC OUT port of battery pack, and the other terminal with output tip into DC IN port of your notebook (you can not insert into in opposite port). Thus, the battery pack is ready for power supply of your notebook computer. The system adopts 5 indicators of LED1~LED5 to display different power status. Press indicator switch (refer to illustration) when the battery pack is in discharge or idle status, if you press the switch POWER, the system will display the rest power of the battery for 4 seconds, details of indicator status are as follows (rest power is R P):
The blink of the first LED means the power is less than 10 or the battery group voltage is less than 10.3V. The power check is the separated module which will not consume the battery energy if no press on indicator button. When one the first LED blinks, the battery pack enters the warning of low power, at the time, please save the file and charge the battery pack in time.
Step 7: In case of large output power or abnormal use, the battery pack will give an alarm when the internal temperature is too high. The
alarm is shown by the second LED light blinking. If it is continued using, the battery pack will shut off automatically. And when the internal temperature decreases to a safe degree, the battery pack will turn on and unchain the safety protection automatically. Then it can be used continuously. The above is normal phenomenon.
2) How to charge:
Connect the selected input tip with the notebook original AC adapter, then connect the terminal with input tip of the AC adapter with the input port of battery pack (input port refers to Illustration), and connect the other terminal with electricity source to charge, the indicator is in red during the charge and turns to green after the charge. Do not discharge your notebook during the charge for improving the charging efficiency. Otherwise, the charge time will be longer.
3) Main Output of Power:
Connect one terminal of the output cable to the output port of battery pack (Output port refers to illustration), and the other terminal to the device requiring charge Note: make sure the battery is at proper output voltage level before connection . If the battery pack discharges, it will offer power supply to notebook firstly and charge the built-in battery with small current, but the battery using rate will be lower, so the better way is to supply power to notebook after your take out the built-in battery.
Download Toshiba Satellite T200 – T410 Battery Pack PDF User Manual
Comments
Leave a Reply