Sony Video System PDF Quick Reference Setup Guide
This guide will assist you in setting up your new Digital Photo Printer. Most of your set up ques- tions will be answered by following these instruc- tions in the order that they are presented. Three standard s-video cables are required to set up this printer. Your KARL STORZ camera comes with an s-video cable, and you will need two additional s-video cables that have been supplied with your shipment.
This type of cable needs to be aligned properly by matching the square hole in the plug with the square post in the cable. Plug the first s-video cable into an s-video output on the back of the camera box and plug the other end into the Y/C IN on the back of the monitor under Line A. Plug one end of the second s-video cable into the other output on the back of the camera box and plug the other end into the S-VIDEO IN on the front of the printer. The third cable connects the printer to the monitor on Line B. One end connects to the S-VIDEO plug located on the back of the printer and plugs into the back of the monitor labeled Y/C IN under Line B.
This allows you to use Line A on the monitor for real-time images, and Line B for capturing and printing. While the image is being printed (approximately 90 seconds), you can continue working by switching back to line A. Load the ink ribbon and the paper. Refer to pages 23-26 in the manual if assistance is needed. Next, the long silver end of the light guide cable is inserted into the light source, and the other end is screwed onto the light guide post of the otoendoscope. The camera head cable must be plugged into the camera control unit. The card edge connector on the camera cable must be dry and clean. It can be wiped with alcohol and allowed to dry completely before plugging it into the camera control unit with the word “UP” visible.
Be sure to hold the box with one hand and push the plug all the way in with the other hand until it can go no further. The camera head is attached to the otoendoscope by squeezing the two rabbit ears on the adaptor and placing the eye piece against the lens. Once the rabbit ears are released, the otoendoscope will be locked onto the camera head. Once the printer is set up and the light source and camera are turned on, there will be an image on the monitor. The red power indicator light on the printer is illuminated when the printer is off. If the red indicator light is not illuminated check to see that both ends of the supplied AC power cord are secured to the printer and your 110v outlet. The red indicator light turns green when the power is switched on. Remember to switch to line B on the monitor when using the printer. The knurled knob on the camera head is the focus adjustment. Point the otoendoscope about 1/2 inch away from an object and adjust the focus ring until the image is clear. Minimal focusing is required after your initial adjustment.
Download Sony Video System PDF Quick Reference Setup Guide
Comments
Leave a Reply