Lovato Easy Fast PDF Installation Manual

1.0 GENERAL RECOMMENDATIONS
• Before installing the gas system, disconnect the battery earth cable (unless specified to the contrary by the car maker). Attention: this may delete the car radio and telephone memories and jam the centralised door locking and anti-theft systems. In this case, you may connect the battery temporarily.
• Always smooth holes after drilling and apply anti-rust to the edges.
• Apply silicon to each cable through-hole to prevent water from entering the interior.
• Install the control unit as far away as possible from areas where water could infiltrate, far away from heat sources (e.g.: exhaust manifolds), far away from high-voltage cables and, wherever possible, with the connector pointing downwards.
• If the fuse blows, do not replace it with one of a higher current rating.
• Do not attempt to open the control unit as this could cause irreparable damage. LOVATO declines all liability for injury to people or damage to property should its equipment be tampered with. In this event the warranty shall also be invalidated.
• Always make electrical connections using the relative joints or soft solder them to prevent the formation of false contacts.
• Always observe the current laws and/or regulations in the State where the LPG system is mounted.
• Remember that, as per the relative standards, all the assembly instructions refer to the driving position.
• Before mounting the electronic control unit, make sure the relative fuses are disconnected.
• Do not wash the engine after installation.

Cut the connectors of connection to the electro-injectors. The wires of a single color have to be connected to the injectors; while the corresponding ones with a black stripe have to be connected to the gasoline injection control unit. Respect the matching between the sheath of the injector emulator wiring and the gas injector. On the injector control, where the gas injector “A” has been connected pneumatically, it is necessary to connect the wires of the sheath “A” of the injector emulator wiring. The same is valid for the other injectors. In case of connection on a 3-cylinder car, the YELLOW AND YELLOW/BLACK wires have to be left disconnected.

8.0 EASY FAST INTERFACE SOFTWARE
8.1 MINIMUM REQUIREMENTS OF THE COMPUTER TO INSTALL THE SOFTWARE
Operating system – Windows 98 2nd edition or following versions
Memory (RAM) – At least 16 MB
Hard disk – At least free 20 MB upon installation
Screen resolution – 800 x 600 or higher
Moreover, it is necessary to have installed Internet Explorer 5.5 or later versions.

8.2 SOFTWARE INSTALLATION
To install the calibration software insert the CD-Rom in the reader of the computer and wait until the guided installation window appears. Should the installation program not start, select “Start” from the “Application Bar”. Select “Execute” and enter: “D:setup.exe” (where “D” indicates the CD-Rom reader). During the installation you will be asked to select the folder in which the program shall be installed. We suggest not changing the pre-set folder. After the installation, the program icon is created automatically on the desktop.

8.3 INTRODUCTION
The calibration software works by hardware key code 7155002 and can be opened without being necessarily connected to the control unit. To connect to the control unit, it is instead necessary that the PC and the control unit are correctly connected by a serial cable (Code 0570001 Installation kit) and a serial USB adapter, if the PC is not equipped with a Serial port (Code 4685001 Serial USB adapter). Moreover, the control unit has to be connected to the +12 volt battery (RED – BLACK wire) and to the ground (BROWN wire).

8.4 MAIN MENU
From this menu, it is possible to access all sub-menus of the calibration software that are given and individually described here below…

Download Lovato Easy Fast PDF Installation Manual


April 22, 2010 | Posted in Software

Related Info:

Comments

Leave a Reply