Kodak Carousel Projectors 4200 Series PDF Service Manual
Section 1:Replacements and Installations
[1] Disconnect the main power.
[2] Remove the PROJECTION LENS.
[3] Remove the LAMP MODULE ASSEMBLY.
[4] Remove the 6TorxSCREWS from the LOWER HOUSING ASSEMBLY.
[5] Pull the LOWER HOUSING ASSEMBLY off the TOP HOUSING.
Replacing the FAN SHAFT ASSEMBLY
[1] Disconnect the main power.
[2] Do the replacement procedure for the LOWER HOUSING ASSEMBLY.
[3] Cut the 3 WIRE TIES:
• 1 on BLOWER COVER wires
• 2 on SMALL CIRCUIT BOARD between the MOTOR and MECHANISM ASSEMBLY
[4] Disconnect the 2 wires from the CYCLE SOLENOID on the SMALL CIRCUIT BOARD.
[5] Pull the SMALL CIRCUIT BOARD up.
[6] Remove theTorx SCREW from the BLOWER COVER ASSEMBLY.
[7] Lift the GRILLE ASSEMBLY in front of the BLOWER COVER ASSEMBLY up.
[8] LoosentheTorxSCREWontherighttrackoftheLOWERLIGHTBAFFLEASSEMBLYappoximatelyhalfway.
[9] Lift the LOWER LIGHT BAFFLE ASSEMBLY off the TAB on the BLOWER COVER ASSEMBLY.
[10] Remove the 2 long
TorxSCREWS from the BLOWER COVER ASSEMBLY.
[11] Lift the BLOWER COVER ASSEMBLY up.
[12] Remove the 3Hex 1/4 in. SCREWS from the MOTOR.
[13] Lift the MOTOR until you observe the FAN BELT and MECHANISM BELT.
[14] Remove the FAN BELT and MECHANISM BELT off the MOTOR PULLEY. Use SPRING HOOK TL-1165.
Move the MOTOR to allow access to the parts; wires are still connected to the MOTOR. Do not cause damage to
the MOTOR wires.
[15] Remove the RETAINER CLIP from the FAN SHAFT.
[16] Pull the FAN up and off the FAN SHAFT to allow access to the FAN BELT.
[17] Remove the FAN BELT.
[18] Remove the 3Torx SCREWS from the FAN SHAFT ASSEMBLY.
Replacing the MOTOR
[1] Disconnect the main power.
[2] Do the replacement procedure for the LOWER HOUSING ASSEMBLY.
[3] Disconnect all wires from the MOTOR.
[4] Cut the 2 WIRE TIES on the SMALL CIRCUIT BOARD between the MOTOR and MECHANISM ASSEMBLY.
[5] Disconnect the 2 wires from the CYCLE SOLENOID on the SMALL CIRCUIT BOARD.
[6] Pull the SMALL CIRCUIT BOARD up.
[7] Disconnect all wires on the MOTOR.
[8] Remove 3Hex1/4 in. SCREWS from the MOTOR.
[9] Lift the MOTOR up to allow access to the FAN and MECHANISM BELTS.
[10] Remove the FAN and MECHANISM BELTS from the MOTOR PULLEY.
[11] Remove the MOTOR.
Download Kodak Carousel Projectors 4200 Series PDF Service Manual
Related Info:
Comments
Leave a Reply